6600, lcd blank keypad light on 20 second off, cant detect.
I have full erase. erase one by one ic flash, flash all ok, still same problem.
Rame and Mjolner have been change, Upp3.2e, Ic flash St.
I try change all ic flash with AMD HT, fl2 no detect id.

have you tried formatting it (that full erase - don't know did you meant format)

you can full format NOKIA 6600: turn off phone, press green key + * + 3 hold pressed anad turn on phone. if that doesn't help.... to service :D that's probabbly best to do..

he said he flashed it which is more efective then formating but it didn´t solve it nonetheless.
i think the problem is bad connections bettween the screen and keypad. better go to a service center to repair.

he said he flashed it which is more efective then formating but it didn´t solve it nonetheless.
i think the problem is bad connections bettween the screen and keypad. better go to a service center to repair.
You have a "hard" problem...not a "soft" problem...scrwedriver!:supz:

topic moved from phones to firmware section ..!!

I Also Had The Same Problem With 7610 I Formatted
& Flashed It Many Times But No Improvement When I Changed
The Uem Ic The Problem Was Solved

this is hardware problem you watch the batt.cannecter upper side two small ics rehot or replace 100% problem is solve

i recently dismantled my 6600 a few times and the last time (9th or so) when reconnecting the screen to the main circut board i may have pushed off centre or something, it didnt seem to fit properly on the plug and rolled in its place.

It worked when pressed and held, approx. 2 mins later only the light and then nothing, now i use remoteS60 on PC to view it.

can only assume that the beer it was dropped in 3days earlier helped.

may or may mot be relative