Hello everyone :)
I just got hold of a Sarasoft HWK box and a set of 60 cables including Nokia N70. With the CD's there was no firmware for the N70 so I got mine from iPhone firmware section. Also there is no documentation whatsoever regarding the N70 in the manual, CDs, etc.

So my problems are:
1. There is an input for a 9volt battery with the cable. When do I connect the battery? After connecting the cable to the box or before?
2. Do I have to keep the original memory card in the phone when flashing? Someone told me I must keep the memory card in.
3. How long does it usually take to flash a BB5 phone like N70?

I used to flash the DCT3 and 4 models but I still need to get familiar with the new generation phones. All your help will be highly appreciated :)

Thank You

1. There is an input for a 9volt battery with the cable. When do I connect the battery? After connecting the cable to the box or before?
for N70 don't need 9v battery

2. Do I have to keep the original memory card in the phone when flashing? Someone told me I must keep the memory card in.
better take out

3. How long does it usually take to flash a BB5 phone like N70?
usually about 10~20min:oops: (i didn't check, but longer than you flash WD2)

Thank You very much UFS-3â. Much appreciated :)

One more question though, It says on the cardbox "No Software Required To Flash BB5 Phones!" What do they mean by that?

*methinks: I wish there was a Nokia Care Center here in my country :(*

just flash n70 with dctxBB5 v1.4e

Thank you very much UFS-3â. I have successfully flashed my N70 :)
It took me approximately 5 minutes to Flash on fast settings.

Thanks once again :)