hi guyz, my 6288 firmware is the latest 6.43, updated with phoenix 2006, but i want to re-install it again with NSU. to change my 6288 product code i use nemesis 1.0.38.10, and when i scan for product the message is :

Reading Virtual USB device...Done.
->Serial: 692F3CDF, HW: 0.0
Testing Interfaces...
->USB DKU2....Supported.
->USB CA-53...Supported.
Testing Directories...
->DCT4 Loaders Dir('Flash')......Found.
-->0 file(s) found.
-->Please copy the loaders first!
->ADSP Loaders Dir('FlashUsb')...Found.
-->0 file(s) found.
-->Please copy the loaders first!
->DCT3 Loaders Dir('fls1sup')....Found.
-->0 file(s) found.
-->Please copy the loaders first!
->Products Dir('products').......Not Found. :!:

i hope its ok, now in phone info, when i scan, it say
"Scan for product ... error" :cry:

next, i open gsmmagic and i click enable, then i change my product code, i click enable again then i click write, it say
"write new values ... error" :cry:

i opened NSU and it said that my 6288 already have latest version, v6.43. but it dont offer to reinstall it. :cry:

what can i do for it? do i have to use phoenix 2007 to reinstall my firmware again or maybe you can give me any idea how to make it work with nemesis.
thx for all your help

You can change product codes with Phoenix when you flash.

thx for the advice, but how can i sure that it will work and dont kill my phone? thx

dont worry use phoenix flash with s40 bb5

if the phone dead after flash or when flash...

you still able flash in dead mode