View Full Version : Toshiba libretto U100 issue after disk change



jendrula
23rd November 2008, 18:21
Hi
I have just upgraded to 60GB disk in my libretto u100. After the full recovery from original disk I found that hardware manager shows three issues. (marked as yellow) ethernet modul(no driver) , mass storage(no driver) and firewire 13 smth (cannot start) All I can instal from toshiba official site dedicated to u100 not suits (problem remains) Is that possible that some tape or connector could dont stick to socket inside and cousing described problem.
What to do? Windows drivers search also not finding adequate driver
Thx for any hint
A

basflt
23rd November 2008, 19:02
does your pc runs normally?

if you dont need those drivers better leave it alone

i have four of those issues in my device-maneger
and last i tried to update , my RAID was gone:forsaken:

jendrula
23rd November 2008, 19:29
All out of expectaction run concerns WIFI..LED working(able to turn off using switch) however windows dont see my wifi.... probably those ethernet unrecogniesed modul is wifi...

basflt
23rd November 2008, 19:55
[Only registered and activated users can see links]

[Only registered and activated users can see links]


[Only registered and activated users can see links]