TMC searches but no connecting.
help please
:hardcry:

I had a similar problem when upgrading to different navcores and the cure for me was to delete the folder named "gns" and replace it with the same folder from a back up which had rds-tmc working correctly on it previously. One of the files must have been corrupted or contained the wrong data. Try it out but make a copy of the original file first so you can always put it back if its a different problem. Let us know if it works for you.

Remove TT from mount
Turn off TT
Turn TT back on and let it start up
Once TT is running and showing you the map put it back on the mount.
Press ok when TMC-RDS error message comes up.

TMC-RDS should now start working. If it doesn't, perform a soft reset between steps 2 & 3.

Have tried both suggestions but without success.

Have tried both suggestions but without success.
Antonolsen,

With navcore SE 8.410 it works. :good2:
Read here : http://www.ipmart-forum.com/showpost.php?p=2568266&postcount=1

Look here : http://www.ipmart-forum.com/showpost.php?p=2605225&postcount=121

grard31

I can confirm that it works on a 910 with 8410.. just been out today and my locked on to a signal after two mins searching.


Gizz

both the 8.410 & 8.204 run the RDS-TMC just fine...

I had a similar problem with my TMC from one day to another - without changing Navcore or anything else: icon in the upper right stayed the car with 'jumping' arrow over it. I was about to purchase a new TMC receiver but then I opened it. After having a look on the contact I recognized that 2 of them were shorted due to bad soldering. So I repaired the soldering and voila: TMC works fine now :)