I have this problem for a long time now, after flashing 2100 the phone can not register to network! AFP for griffin have problems with FAID set and unlock?! Does anybody have this problem and how to solve it ???

try to use another software !! some 2100 griffin can't flash ..!!

hi

griffin can flash 2100 100%
after flash use noktool v 1.8 to rebuild emei

and the phone will be ok


br
:wink:

Hi,
You try change new hagar ang cobba ic ,I'm changed it,now ok
befor change it u tried in to menu seting and choose sub menu select Network the typ Manual,
If show all operator service in your country is have the problem at TX part ,

Hi,
You try change new hagar ang cobba ic ,I'm changed it,now ok
befor change it u tried in to menu seting and choose sub menu select Network the typ Manual,
If show all operator service in your country is have the problem at TX part ,

But, If not show all operator in your city is has been the problem at Rx part,
or you check rf frequency by mobile test set equipment.

Thanks,

rebuild imei

hi
use geo flash then rebuild IMEI

Problem is solved with 2100! Just unmark FFSet and flash the phone with the same or higher version of software, DO NOT EVER DOWNGRADE THE SOFTWARE VERSION!!! And don`t try to repair hardware if the phone losses network after flashing! Thanks to all for posts and sugestions. Good luck :wink:

Yep, try another software . I often find same problems. Use Knok Built 1 support 2100. just erase full / a whole flash .
Flash it with lower version like 5.41. U can flash with Griffin again too. Then it must be connected with Noktool 1.8. Do everything menu. Always Ok !Beleive me no problem with lower version with dct-3...

thank

--------------------------------------------------------------------------------

1. 22222222
2. FFFF9xxx
3. 0000D303 / 5555FFBC
4. 5C:FFFFFFC1
5. 33333333
6. 11:FFFF8200
7. 9xxxx
8. DE:3451
9. BDBDADAD
10. 78878778
11. FFFFFFD4

1. [22222222]
Caused by:
Wrong setting of griffin (Folder settings (C:\Program Files\Nokia\Phoenix\Products\NHL-1/2/3/4/5/6 etc) try unistall and then reinstall everything.
Phone hardware problem.
BAd FIA file structure

2. FFFF9xxx
Caused by:
All FFFF9xxxx error got to do with the connection.
Tip: Try bending the battery connectors upwards, sometimes the connection is not good enough.

3. 0000D303 / 5555FFBC
Caused by:
No connection to the phone or halt button was pressed

4. 5C:FFFFFFC1
Caused by:
appears on 9210's. Try reflashing in safe mode
Mybe is your flash ic is corrupted...or you need to reball the flash ic and try to reflash again.

5. 33333333
Caused by:
Using a un-activated box. If your box is V2.42 and unregistered you will get this error code

6. 11:FFFF8200
Caused by:

7. 91xxx
Caused by:
Cable error

8. DE:3451
Caused by:
Solution: Use Griffin v1.988 or v1.989. And check the "Skip Bluetooth Flashing"

9. BDBDADAD
MCU and PPM versions are not the same

10. 78878778
Possibly no corresponding .fia file or flash chip is dead. In Griffin software versions lower than 1.983 occur while flashing 7650 and 3650 – need to be updated

11. FFFFFFD4
While flashing 3650 means that the box isn't updated to use with 3650. Upload last .gpd file to box