hi
i want learn how to change ic's.pls send me short and easy way hint for this.

first you need hot air station. then you need practice practice practice. use a lot of flux. first try on older boards

first you need hot air station. then you need practice practice practice. use a lot of flux. first try on older boards


using lots of lots of flux will damage your board lol :x :x
repairing most important thing is clean coz it will give u less problem m8

1.GET SOLDER STATION
2.GET FLUX
PUT SOME FLUX AROUND IC YOU WANT TO CHANGE/REMOVE
SWITCH ON SOLDER AND WAIT FOR WHILE THE TEMPERATURE BECAME ABOUT 400C
THEN SOFTLY PUT SOLDER OVER IC AND HOT IT TILL IT COME TO MOVING WHEN YOU TOUCH IT BY SOMETHING AFTER THIS REMOVE IT
CLEAN BOARD FROM FLUX AND REMOVE BALLS
AFTER THIS TAKE MATRIX AND REBALL NEW IC PUT NEW IC ON BOARD AND HOT IT AND THEN IC TAKE IT PLACE BY ITSELF
BUT DONT HOT IC VERY MUCH COZ YOU CAN DAMAGE IT
AND LOT OF FLUX DIDNT DESTROY YOUR BOARD JUST CLEAN IT AFTER THIS
BUT LESS OF FLUX CAN DAMAGE BOARD