Try to upload 2300 pm from latest griffin installer but not help.
Anybody have a good one?
Pls help & thanks for share......

y u need for ??

The phone is CS....
- back up a pm file
- flash erase file to phone
- flash with latest mcu+ppm
- upload its pm

The result is still CS.......
Try to upload 2300 rm-4 pm file from latest griffin installer, the problem is still the same...:(

Any idea....???

problem solved....

problem solved....

hey how did you solve iy i too have the same prob

very simple.....
- erase flash
- flash with mcu+ppm rm-5
- upload good pm
- unlock
- flash again with mcu+ppm rm-4
- done......

If not works then simplay try this
1 . Flash with eeprom eerase bin of 1100 rh18
2 . Flash with RM 4 MCU+PPM
3 . Unlock to remove C.S
4 . Write good a PM file of RH 18

All done for your RM 4
It is working again

Thank you!!!

If not works then simplay try this
1 . Flash with eeprom eerase bin of 1100 rh18
2 . Flash with RM 4 MCU+PPM
3 . Unlock to remove C.S
4 . Write good a PM file of RH 18

All done for your RM 4
It is working again

so if i have a C.S phone after flashing it it still gives CS until i unlock it??
i mean i must press the unlock after the flashing for the phone!!
thanx

yes u need to press the unlock after flashing for the c.s.

yes u need to press the unlock after flashing for the c.s.

is this for all phones including 3650/3660/6600?
does the C.S means contact retailer msg or there is a contact service msg too??
thanx

yes u need to press the unlock after flashing for the c.s.

is this for all phones including 3650/3660/6600?
does the C.S means contact retailer msg or there is a contact service msg too??
thanx

no
contact retailer for 3650,3660,6600 and all WD2 phone is 'format user area'
the phone must in 'local mode' or 'test mode' 1st then you can use the 'format user area' function

@pupy_jai
thanx for your explaination..it is helpful :D