Need urgent help with my Griffin Box...

--------------------------------------------------------------------------------

Hi all,
Can somebody help me how to solve this problem with my Griffin Box (most wanted are instructions from GriffinTeam). Until yesterday it was working perfectly, but I had extended the box with the two cables that I have received when i bought it, because the cables (parallel ones) were too short. After this I tried to operate with the Griffin, but it always said Bad activation status, so I saw that it doesn't work, and removed one of the parallel cables. Now it is not working like it did before. When I try to flash phones it can not autopower the phones, but I choose No at the message "Griffin failed to autopower the phone, power on the phone manually" so it starts to flash the phone but when it goes to the end of flashing procedure, again the message "Griffin failed to autopower the phone, power on the phone manually" appears and I cannot revive any more Nokias because they don't power up at all with the Power On/Off switch.
Just one more thing to add. It is working with the unlock correctly. Please can somebody give me an advice what to do.
Is there any solution for this, I am crying for My Grifin Box. Life is impossible without Griffin.
Thanks in advance...

have u try to flas anther phone ? is work or not ? where did buy u griffin box from ?

when I flash some DCT-3 phones with Contact service and startup self-test only EEPROM tune checksum for example I always get Contact service again

If Griffin failed to autopower the phone change the power adapter.Or reinstal griffin sw

if flashing DCT3 phone don't used griffin ! we can used sorfwear only don't need box !

Need urgent help with my Griffin Box...

--------------------------------------------------------------------------------

Hi all,
Can somebody help me how to solve this problem with my Griffin Box (most wanted are instructions from GriffinTeam). Until yesterday it was working perfectly, but I had extended the box with the two cables that I have received when i bought it, because the cables (parallel ones) were too short. After this I tried to operate with the Griffin, but it always said Bad activation status, so I saw that it doesn't work, and removed one of the parallel cables. Now it is not working like it did before. When I try to flash phones it can not autopower the phones, but I choose No at the message "Griffin failed to autopower the phone, power on the phone manually" so it starts to flash the phone but when it goes to the end of flashing procedure, again the message "Griffin failed to autopower the phone, power on the phone manually" appears and I cannot revive any more Nokias because they don't power up at all with the Power On/Off switch.
Just one more thing to add. It is working with the unlock correctly. Please can somebody give me an advice what to do.
Is there any solution for this, I am crying for My Grifin Box. Life is impossible without Griffin.
Thanks in advance...

that was ur parrellel cable problem ...try both parallel mayb 1 of them was damaged and 1 was fine :roll: :roll: :roll: