hi can anyone tell me which files to use in the mcu, ppm and cnt entries in n-box program. I have installed the nokia pack for 6230 v5.24, but not sure which file extensions should be used with each entry, can anyone help?
Many Thanks
:cry:

No need to answer all is sorted!!!
:mrgreen: :lol: :oops: :D

mcu: usually bigger file size than ppm... and usually has the number 0 at the end of it's filename
ppm: usually has letters at the end of it's flash file
content file: has ucp on it's filename... :D


hope this helps....

first
mcu has the name of phone like nhl-10
and end with 0 number
and the ppm end with aletter like g or f or e some thing like that
u can look for the ppm that include ur langue and chose after u make check for u mobile and u can go

So what does pm file look like??

Thanks, I was wondering about this also!

Thanks, I was wondering about this also!
Found out all you do is read pm and save the file and then write saved file back. EASY. :D

ggasdfadsf

For the Nokia WD2 series, they only have MCU and PPM files. So MCU files normally contains a letter at the end (e.g. nhl830454.7C1) and for PPM files, they end with numbers and do not have any letters included at the end (e.g.nhl830454.701).
Always make sure when you are flashing the phone that the first number of PPM (e.g. *********.7**) matches with the first number of the MCU (e.g. *********.7**).
For the PPM, each different number at the end (e.g. nhl830454.701 and nhl830454.713) are different language packs.