Dear users,

We would like to announce new firmware release: Smart-Clip v2.22 and SmartMoto v1.14.

Added support of Motorola E770 & V3x cell phones models.

Unlock procedure for E770 & V3x Motorola phone with testpoint.

Using "Unlock via Testpoint" function of SmartMoto method

- Perform corresponding testpoint procedure;
- Use "Unlock via Testpoint" function of SmartMoto from "Unlock" tab.

Please remember!
During testpoint unlocking procedure phone's LCD must be disconnected.
Do not use hot air fan to remove a metal shield on PCB. This can seriously damage the handset. Use any other alternative tool to cut or drill it. Please make sure you do not damage the board.

Also, added support of Write/Read process for the models V975,V1050, E1000 with blank-mode & 64mb flash-chip.

Wishing you the best,

Smart-Clip ON!



Best Regards
Smart-Clip Team
www.smart-clip.com
www.GsmServer.com
www.boot-loader.com
www.smart-unlocker.com

Isaac how do we actually cut open metal shield on c975 and others cos i already killed one months ago.There must be a better way.

Dear everyone, Problem of the new version of smartMoto v1.12 frimware v2.21. is when remove RSA of V3 boot loader v 8.26. it sometime show timeout at the 70% of writing. then ur phone will dead. Try to remove again, it show Don't need to remove just Unlock...
I met this problem b4, but for old smart moto v1.10 it can remove again.
Now why this new version make it bug like this. help!!! :-(

try . to disable some background running programs .

and always use fully charged battery and smart clip connected with power supply always solved this problem.. because when smart clip on operation it use heavy resource on LPT port .,

When phone dead, U need to write Full Flash. Spend alot of time.
I wish Smart-Clip team should think about this agian.
As I see the old version of SmartMoto v1.10 never had this problem.
It can re-erase RSA if it is stop during writing boot loader...