I recently purchased UFS3 with HWK. But the problem is I don't know where to start the installation procedure to connect UFS with computer. I recieved 10 CD's numbered from 0 to 9 with UFS3 and 3 CD's with HWK. I learned that the whole installation procedure will occupy atleast 10 to 12 GB of harddisk space, so I merged all the unused partitions in my computer and ready for the installation.

So, I needy an advice from u people that how to start with the installation. Please guide me.

Thanks

(leave box disconnected) first install the ufs_hwk suit(main operating software). after you installed this, start decompressing all the phone files in disc 0-9 to allocated folders in the nokia and sarasoft files(usaully does this for you, just extract files.) once you installed the operating software, and all the phone files, plug the ufs box to computer... should be recognised as new device on computer, select "specify location" when driver installation wizzard appears(depending on your version of windows).. browse till you find the usb_driver folder in the sarasoft file, then click ok. when ufs3 device is installed, restart computer and try the programmes... if you have troubles, post them here, i will try help you, coz it can be frustrating at times... GOOD LUCK

oh, almost forgot.... all dct3 nokia phone files are placed in the "Wintelsa" in C: drive.... all newer nokia files are plced in the products folder in nokia...

Thanks DaSGT for ur kind support. As per the instruction i installed HWK Disk 1 and all the disk of UFS 3 and remaining disk of HWK. UFS3 installed properly.

But when I connect my 6600, and when I used the Check button It says that "1st Boot err: Bad Resp UFSx". I called up my dealer to look further with this error, he did some minor changes in it and it worked fine in his computer. But when I connect it into my computer It again gives the same Error. Then I thought that Let me try to connect this in my institute where I am learning Mobile repairing. It work fine at my institute.

I am not sure, but the problem is with My USB. Because all the computers where I connected, are using USB 2.0 and mine is USB 1.0 (The old pentium 4 motherboard). Is this true that UFSx required USB 2.0 only?