hackenggr
20th February 2006, 08:12
When I flash the Nokia 3310 using UFS-3 Box it give me a problem that after flashing it not pick up the service signals. How I correct that problem?
Faisal Bhai [Hack Engineer]
Faisal Bhai [Hack Engineer]
|
View Full Version : Flashing Nokia 3310? hackenggr 20th February 2006, 08:12 When I flash the Nokia 3310 using UFS-3 Box it give me a problem that after flashing it not pick up the service signals. How I correct that problem? Faisal Bhai [Hack Engineer] g88 20th February 2006, 18:29 When I flash the Nokia 3310 using UFS-3 Box it give me a problem that after flashing it not pick up the service signals. How I correct that problem? Faisal Bhai [Hack Engineer] Haha..finally mr. Hack Engineer have problem. Try flash again. Upon flash do some RF-Tuning. houdanii 22nd February 2006, 05:24 but i have the same problem if i flash a good 3310 when finished she have the same problem i dont know if my UFSxbox or something else ?????????????????????????????????????????????????? ???????????????? Fcs 23rd February 2006, 10:46 fill pmm with virgin eeprom.then reflash just pmm section. edocomsel 25th February 2006, 08:20 Do Full Factory reset, rebuild imei, and init simlocks... thanx polo2828 2nd March 2006, 22:38 Yes your only problem with your upgrade it's only that you forget to apply a reset FAID, the function SP and SFR. Good courage!:rolleyes: techbug 3rd March 2006, 12:22 i think faisal bhai needs the downgrade of software i faced this problem before my board was the old made and i flashed the new firmware and it dorped the Signals [no signal at all] then i downgrade it and i was out of that TechBug houdanii 23rd March 2006, 01:22 thanks but you can poste the firmware PLZ trayeu 27th March 2006, 12:34 Factory reset, rebuild imei, and init simlocks...:rock: romar 5th April 2006, 08:30 first of all you should post the problem of the unit before you flash it is it a dead unit, if you have just upgraded it just check all the UI options and its done. if the unit is a dead one then after flashing it and its ok and you perform all the ui options and still no signal maybe he problem is hardware already.. fbus02 9th April 2006, 06:02 it is better to use the so called Banana as a flashing tool for DCT-3 phone like 3310 i suggest full flash which means MCU, PPM & EEPROM then use nok tool by Rolis for set Faid good luck bababango 22nd April 2006, 12:01 topic moved from phones section to firmware section..!! |